Touch Lamp Wiring. You could simply wrap the wire around an exposed screw or other point, but for best results, solder the. For lamps that have the switch on the socket, you will need to replace the socket.
Touch Lamp Sensor Wiring Diagram General Wiring Diagram from galvinconanstuart.blogspot.com
Grab one of the cord wires in each hand. Web attach the yellow wire from the touch module to the body of the lamp. If the body of the lamp is made of plastic, the sensor can be a small metallic part.
Next, Identify And Separate The Neutral Wires.
Web firstly, get rid of the current touch control box. You can use an orange wire nut to twist the wires together so that they will fit more neatly into the box. Web wire for touch sensor connection.
The Touch Sensor Is Us Ually The Metallic Body Of The Lamp.
Web there are 2 types of touch control switches: After wiring the lamp, attach the opposite end of the wires to the lamp. You could simply wrap the wire around an exposed screw or other point, but for best results, solder the.
On/Off And 3 Way (Low, Medium, High).
Slice through1/2 inch of the membrane at both ends of the cut with a utility knife. The both look the same and are wired the same. Once the lamp is wired correctly, apply electrical tape to the.
You Can Cap It By Twisting The.
Secure them tightly with the wire nuts. You can also simply leave the existing switch in place with the lamp. Grab one of the cord wires in each hand.
Now, Put The New Touch Control Box In.
If the body of the lamp is made of plastic, the sensor can be a small metallic part. Web if one gang ofa touch switch doesn't have any lamps connected, it is normal for the other gangs. Attach the black wire from the plug to the black wire of the sensor.
